We make room for your EV chargers.

How It Works

1. 01Determination

   Your utility's 12-month record shows how much of your service is in use.

   1. Connect the utility account12 months of demand, every 15 minutes.
   2. Or upload the billsAny bill that shows kW.
   3. Photograph the panel scheduleEvery circuit, typed into a record.
   4. Your Capacity ReportWhat the service carries, and how much room is left.

   See a sample Capacity Report →Order a Report →

   Determination, sheet 1 of 24. Read this page first

   The service supports the addition.

   Proposed new load

   +96.0 kVA

   Existing demand, measured

   289.4 kVA

   Existing load, local code method

   361.8 kVA

   Headroom after addition

   207.3 kVA

   Verdict: supports the additionMethod: existing load from measured demand

   Engineer-reviewed, not signed. Sep 2, 2026

   Marina Logistics, Panel A additionWattif / WTF-2417 / SHT E-000
2. 02Investigation

   Meters on your circuits show which loads set your peak.

   1. Map the loadsEvery circuit to its load, and every load to its zone and process: food preparation, refrigeration.
   2. Find the busiest momentOne 15-minute interval sets the peak.
   3. See what was runningEvery load's share of that moment.
   4. Protect what must runLife safety, and anything you name.
   5. Find what can changeLoad at the wrong hour, or working harder than it needs to.
3. 03Intervention

   We identify which loads can change, and how many amps each change frees.

   • Switch off unused loads12 A
   • Change when it runs23 A
   • Run only with another load18 A
   • Start one at a time34 A
   • Adjust setpoints7 A
   • Clean and repair9 A
   • Balance the phases22 A
   • Filter out harmonics15 A
   • Correct the power factor31 A
   • Slow fans to the load14 A

   Three rooftop units that start together

   412 Aat the peak

    

   Start them one at a time
4. 04Control Logic

   We design control logic for your site that respects every constraint and never puts your operation at risk.

   1. We map your peak dayWe show when your site uses the most power, and what happens when the new equipment is added.
   2. You choose what can pauseYou tell us which equipment can pause and for how long. Cold rooms and safety systems are never touched.
   3. We write a rule for each piece of equipmentFor example: when the site gets close to its limit, pause rooftop unit 2 for up to 15 minutes. You approve every rule.
   4. If anything goes wrong, it stopsIf readings stop or something looks wrong, your equipment goes back to running normally.
5. 05Managed Capacity

   We keep your peak under the limit.

   1. We watch the peak as it buildsEvery 15 minutes, against your limit.
   2. Your rules act before the limitOne load eases off for a few minutes, then comes back.
   3. What you need is never touchedProtected loads are never on the list.
   4. Held, month after monthEach month's peak, measured on your panel.

   See how it runs on one panel →