Cold Storage & Warehouses
Your compressors run 24/7.
Nobody's watching the pattern.
$30,000–80,000 a month on electricity. Refrigeration is 70% of it. After every defrost cycle, every compressor restarts simultaneously. That single 15-minute spike sets your demand charge for the month. It happens every day. Nobody sees it.
Your team already sees the problems
Your dock workers and shift supervisors already notice equipment changes, temperature issues, and door problems every day. A tap on a Sense Tag captures what they see. Wattif connects it to energy data and finds what it costs you.
Zones
Staff tap to report
Today's reports
Cool Room A: Temperature feels off
Loading Dock: Door seal ice buildup
Cool Room A: Still warm
Compressor Room: Compressor sounds different
Cool Room A has had multiple temperature reports this week, all during delivery windows. Loading dock ice buildup started 3 days ago and is getting worse. Compressor room sound report is new — first time staff have flagged noise there.
What Wattif sends you
Wattif
online
Cool Room A: 2 temperature reports in 40 minutes. Both during afternoon deliveries. Reports trending up this week.
Compressor Room: unusual sound reported. First report for this zone. Worth investigating on next service visit.
How Wattif understands your operations
Wattif starts with your operations — schedules, equipment, how your facility runs. Then it connects what your team reports to what the data shows.
Your operations
Temperature setpoints and zones
Delivery schedules and dock procedures
Defrost timing and sequences
Equipment age and service history
Wattif asks: What are your temperature setpoints? How many zones? What are your delivery schedules and dock procedures? When do defrost cycles run? It needs to understand your operation before diagnosing your energy.
Consumption analysis
Baseload climbing steadily
Compressor degradation over months
Demand spikes at defrost
Simultaneous compressor restart
Overnight load higher than expected
Door seal leaks suspected
Upload your retailer data or connect your meter. Wattif finds: baseload climbing steadily (compressor degradation), demand spikes at defrost (simultaneous restart), overnight load higher than expected (door seal leaks).
Sensor kit
Recommended kit: 4 circuits
Main incomer
Total load and demand limit
Refrigeration circuits
Compressor health and cycling
HVAC
Ambient zone control
Dock door monitoring
Infiltration tracking
Wattif recommends which circuits to monitor based on what it already knows. Main incomer, refrigeration circuits, HVAC, dock doors. CT clamps clip on in 15 minutes. Baselines in 7 days.
How Wattif thinks about your facility
Not dashboards. Not temperature alarms. Continuous reasoning across refrigeration, operations, and staff reports.
How Wattif acts in your facility
Four ways Wattif takes action. Each one logged, verified, and reported on WhatsApp.
At portfolio scale
Every facility benchmarked
Compare energy per cubic metre across sites. Wattif finds the outlier, identifies the cause, and rolls the fix across the portfolio.
Compressor fleet intelligence
Same model across 5 sites, one degrading. Pattern from one teaches all. What happens in one facility teaches Wattif about all of them.
Standardised defrost profiles
Build optimal defrost sequence from best site. Roll out everywhere. Consistent performance across the portfolio.
Portfolio reporting
Energy, equipment health, compliance data across all facilities. Ready for ESG, audits, or board reporting.
Refrigeration is 70% of your bill.
Wattif watches every compressor.
Start with one facility. In 30 days, Wattif delivers an Intelligence Report with demand charge analysis, defrost scheduling, and degradation detection.
Start with one facilityFree to start. No commitment until you see the report.